Fix 2: Clean destination disk via clean command Type “ chkdsk : /r” to repair the found error. If you want to check H: drive, then you should type: “chkdsk H: f”.ģ. Press Windows + R key and type “ CMD” in a Run box to bring out a command prompt.Ģ. If it's related to writing data, check the destination disk.ġ. If the error is related to read data, you should check the source disk.

Macrium Reflect error 0 or error 8 is very likely caused by bad sectors, so you can check the disk for bad sectors first. Fix 1: Check bad sectors via chkdsk command You can try them one by one and check if it works for you. Before that, you need to create a file backup for your personal data in case something unexpected happens.ĥ Effective Solutions to 'Macrium Reflect failed to clone'Īccording to the possible reasons, I'll offer you some solutions. Next, you need to try the given methods below and find the one that works for you. To ensure the security of your computer, the antivirus software may refuse to clone the system files on the disk and then the process failed. Antivirus software is enabled and it prevents Macrium Reflect from cloning. If the destination disk has a corrupted or damaged file system, you cannot clone disk with this software successfully.Ĥ. If there is a bad sector on either source disk or destination disk, you will receive this error when it encounters the bad sector during the cloning process.ģ. To exclude this possibility, you need to check the cable connection and clone it with Macrium again.Ģ. This is the most simple reason for Macrium Reflect clone error. The cable connection between the drive and computer is not proper. If Macrium clone failed with error 0, error 8, error 9 and so on, you may consider the following reasons:ġ. Reasons for 'Macrium Reflect clone failed'Įvery error has its cause. In addition to error 9 in the above case, you may also receive read failed 13 broken pipe, failed to create volume snapshot, 0x8000ffff, permission denied, read failed 22, write failed 22, invalid argument, disk not found, verify file system failed, error 8, error 0, etc. I keep getting an error when I'm close to done (95%+): error 9: error code 1117, I/O device error. I'm trying to move a smaller old HDD to a new SSD.

Macrium clone disk